1KV IPC 3.3 120-185/16-25 ABC Wire Fire-retardant Puncture clamp IPC, China 1KV IPC 3.3 120-185/16-25 ABC Wire Fire-retardant Puncture clamp IPC Manufacturers, Suppliers, Factory -Wenzhou Feman Electric Co., Ltd

General of insulation piercing connector(lPC)

Key Features:

Range-taking

Suitable for XLPE, PE or PVC conductors

Waterproof

Captive and flexible end caps

All components are solid and fixed in place

Equipped with shear head to ensure a reliable tightening torque

Operating temperature -55°C to +55°C

Installation temperature -20°C to +55°C

Can be installed on energized main if not under load

Full range of ABC Insulation Piercing Connectors used to tap off low voltage XLPE insulated Aerial Bundled Cable (ABC).

1).Adjust the connector nut to suitable location.

2).Put the branch wire into the cap sheath fully.

3).Insert the main wire, if there are two lays of insulated lay in the main cable, should strip a certain length of the first insulated lay from inserted end.

4).Turn the nut by hand, and fix the connector in suitable location.

5).Screw the nut with the sleeve spanner.

6).Screw the nut continually until the top part is cracked and dropped down.

What are the applications of insulated piercing connectors？

As the name suggests, insulated piercing connectors complete the connections from the main wires to the subsidiary wires. One common application is on the street lights where they connect the lamp wire to the main live conductor.

How to install an insulated piercing connector?

For proper insulation, you will need a spanner. You should also be cautious with the live wire when installing this transmission line accessory.

Start by identifying the correct cable from the cable and isolate it using a phase separator. Insert the selected cable into the piercing tap of the clamp. This tap is on the main side of the clamp.

Loosen the shear nut to properly accommodate the cable in the tap. You can then tighten the nut using a spanner until the top hex shears off.

Dimensions
Main Cable Line:	120-185mm²
Branch Cable Line:	16-25mm²
Main Ingredients	Thermoplastic Fibre Glass Reinforced Reinforced nylon
Features
Bolt:	1
Mechanical detail
Tightening Torque:	15±1NM

Description：

Insulation piercing connector is a cable connection product that replaces junction boxes and T junction boxes. There is no need to cut off the main cable during construction, and branches can be made at any position of the cable. There is no need for special treatment of wires and clamps, and the operation is simple and fast.

Quick Detail:

Different terms for products:IPC, Insulation piercing connector, insulation piercing clamp, cable connector, LV ABC cable connector

Main uses:The use of insulation piercing connector is another cable T connection method after cable distribution boxes and pre-branch cables. It can be used in low-voltage power and lighting distribution lines such as high-rise buildings, residential buildings, street light distribution, and outdoor overhead lines. It can be installed in shafts or in the open air.